A SERVICE OF

logo

Open as PDF
next previous
4
Assembly
• Whileholdingthepedalhubsonthepedalaxle,insertthe
pedalaxlethroughtheholeinthecenterofthefrontwheel.
• Pushthepedalhubsintothecenterofthefrontwheeluntil
theyareushwiththesurfaceofthefrontwheel.
Hole
PedalAxle
PedalHubs
FrontWheel
• Placeascrapblockofwoodunderthefrontwheelassembly
withtheexposedendup.
• Fitapedalonthepedalaxle.
• Tapthepedalwithahammeruntilitissecure.
PedalAxle
FrontWheelAssembly
Pedal
PedalHub
PedalHub
PedalAxle
• Turnthefrontwheelassemblyover.
• Insertapedalhubontothetopofthepedalaxleandinto
theholeinthecenterofthefrontwheel.
• Inserttheremainingpedalhubbelowthepedalaxleand
intotheholeinthecenterofthefrontwheel.
• Pushthepedalhubsintothecenterofthefrontwheeluntil
theyareushwiththesurfaceofthefrontwheel.
5
6
7
• Placethefrontwheelassemblybetweentheforkarms.
Makesurethepedalaxletsintothegrooveatthebottom
ofeachforkarm.
• Placeaforkcoveroverthepedalaxleononeforkarm.
• Inserttwo#8x
3
/
4
"(1,9cm)screwsthroughtheforkcover
andintotheforkarm.TightenthescrewswithaPhillips
screwdriver.Donotover-tighten.
• Repeatthisproceduretoattachtheotherforkcovertothe
otherforkarm.
ForkArms
PedalAxle
Groove
ForkCover
8