364
CHAPTER 18 8-/10-BIT A/D CONVERTER
18.5.3 Pause-conversion Mode
In the pause-conversion mode, A/D conversion starts and pauses repeatedly for each
channel. When the start trigger is inputted after the A/D conversion pauses at the
termination of the A/D conversion for the end channel, A/D conversion is continued after
returning to the start channel.
■ Setting of Pause-conversion Mode
Operating the 8-/10-bit A/D converter in the pause-conversion mode requires the setting shown in Figure
18.5-3 .
Figure 18.5-3 Setting of Pause-conversion Mode
PAUS STS1 STRTSTS0BUSY
INT
INTE
ADCS
11
0
MD1 S10MD0
−−−−−
−−−−−
−
CT1CT2 CT0ST1ST2 ST0
ADCR
ADER5
bit15 14 13 12 11 10 9 bit8 bit7 6 5 4 3 2 1 bit0
ADSR
ANS1 ANS0 ANE1
ANE0
ANE2ANE3ANS2ANS3
ADER6
ADE15ADE14ADE13ADE12ADE11ADE10 ADE9 ADE8
ADE7 ADE6 ADE5 ADE4 ADE3 ADE2 ADE1
ADE0
1
0
−
00
Re-
served
D9 to D0 (Converted data stored)
: Setting 1
: Set the bit corresponding to pin to be used as analog input pin to 1.
: Used bit
: Undefined
Re-
served
Re-
served
: Setting 0
