Warning
Failure to avoid the following potentially hazardous situations could result in an accident
or collision resulting in death or serious injury.
Do not open the VIB or loosen the case screws. Doing so will void the warranty.
When extending ignition, battery, or ground wires, use automotive-grade wires or other wires
with AWG 18 (0.75 mm2) gauge or greater.
Connect the ignition wires to a power source that can be turned on and off with the ignition
key. If you connect the ignition wire to a power source with a constant voltage supply, such as
battery wires, the vehicle’s battery may die.
•
•
•
Make sure to ground the VIB to the chassis of the vehicle.
Secure all wiring with cable clamps or electrical tape. Insulate unconnected wires; do not
allow any bare wiring to remain exposed.
Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can
conduct electricity.
Do not expose the unit to water or other liquids. The unit is not waterproof.
Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity,
or dust.
•
•
•
•
•
NOTE: There may be additional signals from the
stereo that are not shown on this diagram. Any such
signals should be connected directly back to the
stereo.
VIB 10/11 24-Pin
Connector
2
23
24
1
Reverse In 1
Mute Out 2
Ground In 3
Ground In 4
12 VDC In 5
12 VDC In 6
Ignition 7
Output Level 8
LR (-) Out 9
LR (+) Out 10
RR (-) Out 11
RR (+) Out 12
LF (-) Out 13
LF (+) Out 14
RF (-) Out 15
RF (+) Out 16
LR (-) In 17
LR (+) In 18
RR (-) In 19
RR (+) In 20
LF (-) In 21
LF (+) In 22
RF (-) In 23
RF (+) In 24
Grey
Grey/Black
White
White/Black
Purple
Purple/Black
Green
Green/Black
Grey
Grey/Black
White
White/Black
Purple
Purple/Black
Green
Green/Black
Red
Yellow
Yellow
Black
Black
Light Green
Pink
Tan
Optional
Optional
Stereo
Ignition
12 VDC
Ground
Vehicle
Ignition
12 VDC
Ground
Vehicle Speakers
LR (-)
LR (+)
RR (-)
RR (+)
LF (-)
LF (+)
RF (-)
RF (+)
Stereo System Out
LR (-)
LR (+)
RR (-)
RR (+)
LF (-)
LF (+)
RF (-)
RF (+)
Ground for Low-level output;
Float for High-level output
Fakra to VIB 11
Ant. In
adapter to
antenna
Vehicle’s
antenna
To Antenna Adapter Cable
Fakra to VIB 11
Ant. Out
adapter to
stereo
Stereo’s antenna
connector
To Stereo Adapter Cable
VIB 11 Antenna Connections
Video In
To PND
(GPS navigator)
Ant Out
to stereo’s
antenna
connector
(VIB 11 Only)
Ant In from vehicle’s antenna
(VIB 11 Only)
Audio Out
(optional)
To Stereo/
vehicle wiring
(24-pin
connector)
VIB 10/11 Connectors
VIB 10/11 Wiring Diagram
VIB 10/11 24-Pin Connector
