METHOD 1–Air Gap with Waste Tee or Disposer
METHOD 2–High Drain Loop with Waste Tee
Use the drain hose hanger included in the installation kit to
attach the drain hose to the underside of the countertop.
Attachment will be made in a later step.
Install waste tee or disposer and the air gap according to the
manufacturer’s instructions.
Cabinet Preparation for drain line
Drill a 1-1/2" diameter hole in the cabinet wall within the
shaded area shown in Figure A for the drain hose. Make
sure there are no sharp edges. The drain hose will be passed
through this hole and connected to the drain in a later step.
connecting the drain line to a
disposer, check to be sure that
drain plug has been removed.
Dishwasher will not drain if
An air gap MUST BE USED if the drain hose is connected
to waste tee or disposer lower than 18" above the floor
level. Failure to provide the proper drain connection height
with an air gap or 32" minimum high drain loop will result
in improper draining of the dishwasher, which may cause
Installation Preparation–Drain
• Drain hose must not exceed 10 feet in length.
• A high drain loop or air gap is required. See below.
The type of drain installation depends on the following:
• Do local codes or ordinances require an air gap?
• Is waste tee less than 18" above the fl oor?
If the answer to either question is
, an air gap must be used.
(Figure C) in the adjacent illustrations.
, either an air gap or high drain loop may
the adjacent illustrations
Drain hose elevation must not exceed 48".
Special consideration for a dishwasher installed on a
lf the dishwasher is installed on an elevated platform, a high
drain loop of at least 32" above the platform must be provided
in addition to the air gap or drain loop requirement determined
above. This is necessary for proper drain performance.
