11
If Something Goes Wrong
Problem Possible Causes What to Do
Washer is unplugged • Make sure cord is plugged securely into a
working outlet.
Water supply is turned off • Turn both hot and cold taps fully on.
Controls are not set properly • Check controls and make sure Cycle knob
is pulled out to ON position.
Lid is open • Close lid and pull Cycle knob out to ON
position.
Circuit breaker/fuse is • Check house circuit breakers/fuses. Replace
tripped/blown fuses or reset breaker. Washer should have
separate outlet.
Washer Won’t Operate
Drain hose is kinked or • Straighten drain hose and make sure
improperly connected washer is not sitting on it.
• Top of drain outlet should be less than
1m (3 ft.) above floor.
Water Won’t Drain
Control is not set properly • Check water temperature control and adjust.
Water supply is turned off • Turn both hot and cold taps fully on and
or improperly connected make sure hoses are connected to correct
taps.
Water valve screens are • Turn off the water source and remove the
stopped up
water connection hoses from the upper back
of the washer. Use a brush or toothpick to
clean the screens in the machine. Reconnect
the hoses and turn the water source back on.
House water heater is not set • Make sure house water heater is delivering
properly water at 48°C.–65°C. (120°F.–150°F.).
Water Temperature
is Incorrect
