1.
Remove the two hood bolts, flats and locks, from
the hood open.
the center bottom of each side of the hood. Pivot
2.
Position the handle into the end of the chassis
closest to the wheels. Line up the four mounting
outside of the chassis. Use flat washers only
on
holes. Install the four
318
x
1
inch bolts from the
head of bolt. Use a flat washer, lock washer, and
nut
on
each bolt on
the
inside
of
the chassis.
3.
Connect one end of the
30
foot high pressure
with
a
threaded swivel fitting. Connect the other
hose to the pump outlet. This connection is made
end to the gun using the quickcouplers provided,
4
002-777
,.
.
.
..
..
. ..
.
,
performance, and chemical injector
performance.
..
..
.
4.
Hood may
now
be closed and secured with hood
bolts, flat washers, and lock washers removed in
Steu
1.
5.
Remove the plastic plug from the inlet hose.
Check the water supply flow rate (see page
5).
Connect inlet hose to water supply.
A
standard
3/4"
garden hose may be-used to connect inlet
hose to the water supply.
i..
~. .
.>
..
,.
,
.
....
.
:
..
..'
,.:
. ..
.
