A SERVICE OF

logo

Open as PDF
next previous
KK-C-VAK_INST_10-07
Route HVAC 2 1/2” blower hoses to the
approximate locations with tape along
ceiling
where they will be installed into the
ceiling insert after Kwik-Kit insert is
installed. Mount hoses with wire ties at
wall and ceiling corners only. Leave
enough slack to reach hoses for permanent
mounting.
Attach the “Y” duct hose adaptor to
the 8 foot front duct hose and
connect both 4 foot hoses from “Y”
to vents in driver and passenger side
front ceiling. This will provide a
total of four ceiling vents.
Route hose straight up from the HVAC unit
and tie tight to corner of the van
When routing the hoses, tie together using
15” wire ties, to keep a neat and tight fit to
the wall of the vehicle.
This will minimize the risk of damage when
installing Kwik kit