Hardware options installation 34
6.
Install the DIMM.
7. Install all DIMM baffles.
8. Install the access panel (on page 14).
If you are installing DIMMs in a mirrored or lock-step configuration, configure this mode in RBSU ("HP
ROM-Based Setup Utility" on page 55).
Mezzanine card option
Optional mezzanine cards are classified as Type I mezzanine cards and Type II mezzanine cards. The
card type determines where it can be installed in the server blade.
• Install Type I mezzanine cards on either mezzanine 1 connector or mezzanine 2 connector.
• Install Type II mezzanine cards only on mezzanine 2 connector.
Optional mezzanine cards enable network connectivity or provide Fibre Channel support. For mezzanine
card locations, see the system board components (on page 9).
For mezzanine card mapping, see the HP ProLiant BL460c G6 Server Blade Installation Instructions or see
"Interconnect bay numbering and device mapping (on page 16)."
To install the component:
1. Power down the server blade (on page 12).
2. Remove the server blade (on page 13).
3. Remove the access panel (on page 14).
