Speaker assembly
Description Spare part number
Speaker assembly (includes cable) 641840-001
Before removing the speaker assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4.
Remove the battery (see
Battery on page 29), and then remove the following components:
a. Service cover (see
Service cover on page 30)
b. Optical drive (see
Optical drive on page 31)
c. Solid-state drive (see
Solid-state drive on page 32)
d. Keyboard (see
Keyboard on page 40)
e. Base enclosure (see
Base enclosure on page 43)
Remove the speaker assembly:
1. Turn the base enclosure right-side up, with the front toward you.
2. Remove the two Phillips PM2.0×3.0 screws (1) that secure the speaker assembly to the
base enclosure.
Component replacement procedures
47
