NOTE:
Product conformance to cited product specifications is based on
sample (type) testing, evaluation, or assessment. This product or family
of products is eligible to bear the appropriate compliance logos and
statements.
Smart Array P410
Controller
Disk Drive and
Enclosure Interface -
Transfer rate
6Gb/s SAS (Serial Attached SCSI)
3Gb/s SATA (Serial ATA)
SAS Connectors
2 internal (Mini-SAS) x8 wide port connectors
Cache Memory Speed
DDR2-800MHz with 40 or 72-bit wide bus provides up to 4.2 GB/s
maximum bandwidth.
Server Interface
x8 5G PCIe 2.0 provides 4GB/s maximum bandwidth
SAS Speed
x8 6G SAS provides 4.8GB/s maximum bandwidth
Cache Memory
40-bit 256MB ECC protected cache (72-bit 512MB BBWC module
upgrades available); transportable with battery-backed upgrade
Logical Drives
Supported
Up to 64 logical drives
Maximum Logical Drive
Capacity
Greater than 2TB
Host Memory
Addressing
64-bit, supporting greater than 4GB server memory space
RAID Support
RAID 6, 6+0 (Advanced Data Guarding)
NOTE:
The minimum of 256 MB cache, battery kit, and Smart Array
Advanced Pack License Key upgrade is required to enable RAID 6, 6+0
RAID 5, 5+0 (Distributed Data Guarding)
NOTE:
The 256 MB is required to enable RAID 5, 5+0 support of the
Smart Array P410i
RAID 1+0 (Striping & Mirroring)
RAID 0 (Striping)
Two HP NC382i Dual
Port Multifunction
Gigabit Server
Adapters
Network Interface
10Base-T/100Base-TX/1000Base-TX
Compatibility
IEEE 802.3 10Base-T
IEEE 802.3ab 1000Base-T
IEEE 802.3u 100Base-TX
Data Transfer Method
PCI Express, four lanes (x4)
Network Transfer Rate
10Base-T (Half-Duplex)
10 Mb/s
10Base-T (Full-Duplex)
20 Mb/s
100Base-TX (Half-
Duplex)
100 Mb/s
100Base-TX (Full-
Duplex)
200 Mb/s
1000Base-TX (Half and
Full-Duplex)
2000Mb/s
Connector
Two RJ-45
Cable Support
10Base-T
Categories 3, 4 or 5 UTP;
up to 328 ft (100 m)
100Base-TX
Category 5 or higher UTP;
up to 328 ft (100 m)
1000BaseTX
Category 5 or higher UTP;
up to 328 ft (100 m)
QuickSpecs
HP ProLiant DL385 Generation 6
Technical Specifications
DA - 13360 Worldwide QuickSpecs — Version 9 — 10.23.2009
Page 41
