A SERVICE OF

logo

Open as PDF
next previous
B-10 AlphaServer GS80 Upgrade Manual
1. Access the top system drawer and remove CPU3 and memory 2 to allow
space to access the clock module.
2. Remove the clock module cover plate in the rear left corner of the drawer
compartment by removing the two Phillips head screws holding it in place
and lift it out of the drawer.
3. Remove the clock compartment shield. Note how the shield is installed.
4. Unplug the coax clock cable(s) from the clock module.
5. Unplug the power cable.
6. Unscrew the four Phillips head screws holding the module to the side of the
drawer and remove the module.
7. Check the bit settings on the two switches. See Figure B-2 for switch
orientation and bit settings.