5.
Remove the solid-state drive connector board cable (see
Solid-state drive on page 35).
6. Remove the Card Reader board cable (see
Card Reader board cable on page 37).
NOTE: When replacing the top cover, be sure to remove the following components from the defective
top cover and install them on the replacement top cover:
●
NFC board (see
NFC board on page 38)
●
Solid-state drive connector board (see
Card Reader board cable on page 37)
●
Card Reader board (see
Card Reader board on page 45)
●
Power button board (see
Power button board on page 46)
Remove the top cover:
1. Release the ZIF connector to which the TouchPad cable is connected, and then disconnect
the TouchPad cable (1) from the TouchPad.
2. Disconnect the speaker cable (2) from the system board.
3. Remove the two rear rubber feet (1).
Component replacement procedures
41
