A SERVICE OF

logo

USB board (see
USB board on page 65)
Power connector cable (see
Power connector cable on page 66)
Display assembly (see
Display assembly on page 68)
NOTE: When replacing the system board, be sure that the following components are removed from
the defective system board and installed on the replacement system board:
Memory module (see
Memory module on page 47)
RTC battery (see
RTC battery on page 81)
Fan/heat sink assembly (see
Fan/heat sink assembly on page 83)
Processor (see
Processor on page 89)
Remove the system board:
1. Disconnect the optical drive connector cable from the system board.
2.
Remove the Phillips PM2.5×6.0 screw (1) that secures the system board to the base enclosure.
3.
Lift the right side of the system board (2) until it rests at an angle.
Component replacement procedures
77