Hunter Fan 45005-01 Manual

next previous

45005-01•11/08/07•HunterFanCompany

7-1. Toattachtheupperswitchhousing,partiallyinstalltwohousing

assembly screws into the switch housing mounting plate.

7-2. Feedtheupperplugconnectorthroughthecenteropeningofthe

housing.

7-3. Alignthekeyholeslotsinthehousingwiththehousingassembly

screws.

7-4. Turnthehousingcounterclockwiseuntilthehousingassembly

screws are ﬁrmly situated in the narrow end of the keyhole slots.

Install the remaining screw into the housing. Tighten all three

screws ﬁrmly.

CAUTION: Make sure the upper switch housing is securely attached

to the switch housing mounting plate. Failure to properly attach and

tighten all three assembly screws could result in the switch housing

ﬁxture falling.

7-5. Toattachthelowerswitchhousing,connecttheupperplug

connector from the motor to the lower plug connector in the

lower switch housing assembly.

Note:Bothplugconnectorsarepolarizedandwillonlyttogether

one way. Make sure the connectors are properly aligned before

connecting them. Incorrect connection could cause improper

operation and damage to the product.

7-6. Placethelowerswitchhousingassemblyovertheupperswitch

housing.Alignthesidescrewholesintheupperandlowerswitch

housings.Attachthelowerswitchhousingtotheupperswitch

housing with three housing assembly screws.

Note:YoucancustomizeyourHunterfanwithanumberofaccessory

light kits.

Steps 7-1 – 7-4

Housing

Assembly

Screw

Upper

Switch

Housing

Housing

Assembly

Screw

Lower

Switch

Housing

Steps 7-5 – 7-6

Plug

Connector

7 • Installing the Switch Housing