English – 21
WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cable is removed from the plug.
• The parking brake is applied.
• The cutting unit is disengaged.
Maintenance
5025
100
MAINTENANCE
Page
Maintenance interval
in hours
Daily
mainte-
nance
before start
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
● = Described in these instructions.
❍ = Not described in these instructions.
1)
First change after 5 hours.
2)
During dusty conditions cleaning and replacement should be more frequent.
3)
For daily use of the
machine lubrication should be conducted twice a week.
4)
Conducted by authorised service workshop.
Check the engine’s oil level 37 ●
Check the engine’s cooling air inlet 30 ●
Check the fuel pump’s air filter 28 ●
Check the steering wires 24 ●
Check the brakes 25 ●
Check the battery 28 ●
Check the safety system 29 ●
Check screws and nuts – ❍
Check for fuel and oil leakage – ❍
Change the engine oil
1)
37 ●
Clean the air filter’s pre-filter (foam plastic)
2)
27 ●
Check the cutting unit 31 ●
Check the tyre pressures (60 kPa) 30 ●
Lubricating the belt adjuster
3)
38 ●
Lubricate joints and shafts
3)
39 ●
Adjust the brakes – Rider 11 and Rider 11 Bio 25 ●
Check the V-belts – ❍
Check the transmission’s cooling flanges –– ❍
Rider 13 and Rider 13 Bio
Check the transmission’s oil level – Rider 13 and 39 ●
Rider 13 Bio
Adjust the brakes – Rider 13 and Rider 13 Bio 25 ●
Check and adjust the throttle wire 26 ●
Clean the cooling flanges on the engine and – ❍
transmission
2,4)
Replace the air filter’s pre-filter and paper filter
2)
27 ●
Replace the fuel filter 26 ●
Replace the plug 28 ●
