English - 21
3. INSTALLATION
Installation and connecting the charging
station
1. Position the charging station in a suitable spot.
2. Connect the low voltage cable to the charging
station.
3. Connect the transformer’s power cable to a
230 V wall socket. If the wall socket is outdoors,
it is important that the transformer is protected
from direct sunlight.
4. Attach the charging station to the ground using
the supplied screws. Ensure the screws are
screwed all the way down in the countersink.
3.3 Charging the battery
As soon as the charging station is connected, it is
possible to charge the robotic lawnmower. Set the
main switch to position 1.
Place the robotic lawnmower in the charging station
to charge the battery while the boundary and guide
wires are being laid.
If the battery is flat, it takes around 80 to 100 minutes
to fully charge it.
It is not permitted to make new holes in the
base plate Only the existing holes may be
used to secure the base plate to the ground.
Do not tread or walk on the charging station's
base plate.
The Automower
®
cannot be used before the
installation is complete.
