35
Maintenance
Chapter 6: Maintenance
It is good practice to always check for leaks and loose components after use. Also check the machine and listen for
knocking sounds. During hard use and in extreme conditions, the service intervals should be reduced.
Check the cooling system’s antifreeze before the Winter.
Maintenance Schedule
The following is a list of maintenance procedures that must be performed on the machine. Paragraphs that are
marked with footnote number 4, see an authorised service workshop.
● = Described in this manual
❍ = Not described in this manual.
Maintenance Page Daily main-
tenance
Weekly
main-
tenance
Maintenance interval hours
Check for fuel and oil leaks - ❍
Check the safety switch, seat 43 ●
Check the safety switch pedal
system, neutral position
43 ●
Check the engine oil level (at every
refuelling)
113 ●●
Check the hydraulic oil level 115 ●●
Check the coolant level 50 ●●
Check/clean the engine’s cooling air
intake, radiator mesh and radiator
38 ●● ●
Check fastenings (screws, nuts, etc.) - ❍
Start the engine and blades, listen for
unusual sounds
- ❍
Clean under the cutting unit and belt
covers
48 ●● ●
Check for damage - ❍
Check the air pressure in the tyres
(100 kPa)
41 ●
Clean thoroughly around the engine - ❍
Clean thoroughly around the
transmission
- ❍
Lubricate according to lubrication chart
3
111 ●●
Clean the air filter and empty the
particle trap
40 ●●
Check the blades 50 ●
Change the engine oil and filter
1
114 ●
Replace hydraulic oil filter and check
the oil level
4, 5
115 ●
Check the tension and condition of
the belts (generator belt, power take-
off belt, cutting unit belt)
38
50
51
●
befor after
