A SERVICE OF

logo

28 IBM Netfinity EXP300 - Type 3531 Hardware Maintenance Manual
2. On the rail marked R, loosen the four screws2and adjust the rail.
3. Hold the rail against the outside of the right rack-mounting flange, and loosely
insert the two front M6 hex screws 1.
4. Extend the rail outside of the rear rack-mounting flange; then, install and tighten
two rear M6 hex screws 3.
5. Tighten the two front screws 1; then, tighten the four screws 2.
Repeat step 2 through step 5 to install the rail marked L on the left side of the rack.
6. Loosely insert one M5 screw 1 into each rail.