12
NS-19E310A13 Insignia 19" LED TV
www.insigniaproducts.com
Using composite video (good)
To connect a cable or satellite box using
composite video:
1 Make sure that your TV’s power cord is
unplugged, and all connected equipment is
turned off.
2 Connect the incoming cable from the cable wall
jack to the cable-in jack on the cable or satellite
box.
3 Connect an AV cable (not provided) to the
VIDEO/Y jack and AUDIO L/R jacks on the side
of your TV and to the composite video and
audio out jacks on the cable or satellite box.
4 Plug your TV’s power cord into a power outlet,
turn on your TV, then turn on the cable or
satellite box.
5 Go through the Setup Wizard on page 20
.
Using coaxial (good)
To connect a cable or satellite box using coaxial:
1 Make sure that your TV’s power cord is
unplugged, and all connected equipment is
turned off.
2 Connect the incoming cable from the cable wall
jack to the cable-in jack on the cable or satellite
box.
3 Connect a coaxial cable (not provided) to the
ANT/CABLE IN jack on the back of your TV and
to the coaxial out jack on the cable or satellite
box.
4 Plug your TV’s power cord into a power outlet,
turn on your TV, then turn on the cable or
satellite box.
5 Go through the Setup Wizard on page 20
.
Note
•The VIDEO/Y, P
B
, and P
R
video jacks (used to
connect a component device) share AUDIO L/R
jacks with the VIDEO/Y jack (used to connect a
composite device).
• When you connect the audio using the
AUDIO L/R jacks, the audio output is analog.
Cable or satellite box
AV cable
Cables are often color-coded to match
color-coded jacks.
Note: The yellow video connector on the AV
cable connects to the green VIDEO/Y jack.
Side of TV
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
Cable or satellite box
Coaxial cable
Back of TV
