7. Remove the MACh Speed G3 from its protective package.
• Now that you are grounded, you can remove the MACh
Speed from its protective package.
• Inspect the card for any irregularities or possible damage
in shipment.
Inspecting the MACh Speed G3
Chapter 2 - Installing the MACh Speed G3 Upg rade Car d
Page 15
5. Remove the CPU card that’s in the computer now.
• Pull the card straight up without rocking it side-to-side.
Do not pull on the heat sink because you may damage the
card or your computer.
Removing the CPU card
6. Reset the motherboard, by depressing the CUDA switch.
• Located directly below the CPU card slot lies the mother-
board reset switch, or CUDA. it is a small red button.
• Depress this switch for 5 seconds with a
small tool or pen point. failure to com-
plete this instruction may cause the
CPU not to be recognized when booted
up for use.
Chapter 2 - Installing the MACh Speed G3 Upg rade Car d
Page 14
reset button
