Pronto®Air Personal Transporter w/ MyBody™ Seating
Disconnecting
1. Hold the light grey collar A portion of the joystick connector B
with one hand and the controller connector C on the personal
transporter in the other and disconnect them by pulling them
apart.
Connecting
CAUTION!
– The joystick connector and controller connector fit
together in one way only. DO NOT force them
together. Otherwise, damage will occur.
1. Hold the light grey collar portion of the joystick connector
with one hand and the controller connector on the personal
transporter in the other and align them.
2. Lightly push to engage the joystick connector and the controller
connector.
Adjusting the Joystick Depth
The same mounting screws used to secure the joystick
mount to the armrest assembly are also used to secure the
arm pad to the armrest assembly.
1. Loosen, but do not remove, the two mounting screws A used to
secure the joystick mount B to the armrest assembly C.
2. Move the joystick mount forward or backward to achieve the
desired position.
3. Securely tighten the two mounting screws.
6.6 Seat and Back
Adjusting the Seat Assembly Height
1. Remove the seat assembly A. Refer to 5.6 Removing/Installing
the Seat Assembly, page 29.
2. Remove the mounting screw B and locknut C that secures the
seat post D to the support tube E.
3. Adjust the seat post to one of five mounting position.
4. Reinstall mounting screw and locknut. Torque 40 ft/lbs ± 10%.
5. Reinstall the seat assembly. Refer to 5.6 Removing/Installing the
Seat Assembly, page 29.
The seat height adjustment is between 19 to 23 inches in 1
inch increments
36 1171794-B
