Invacare 9000 XDT Manual

A SERVICE OF

next previous

SECTION 5—SEAT TO FLOOR

Part No. 1076155 37 9000 Series

24-Inch Rear Wheels and 6-Inch Front Casters

ƽ WARNING

If changing the seat-to-floor angle to 6°,

anti-tippers MUST be installed.

Refertothefollowingtabletodeterminetheobtainableseat‐to‐floorheightsand

seat‐to‐flooranglesfor24‐inchrearwheelsand6‐inchfrontcasters:

*NOTE:Theseat‐to‐floorheightsarebasedonurethanetires.Ifwheelchairisequippedwith

pneumatic(properlyinflated)orsolidrubbertires,add¼inchtothemeasurementslistedabove.

Theseheightscanvary+/‐¼inchduetotirewearandmanufacturingtolerances.

NOTE:Charts9to14applytoadult/hemiframestylesonly.Refertothechartsforseat‐to‐floor

heightsettingsforadult/tall(Adult/TallFrameStyleonpage 31)andsuperlowframestyles

(SuperLowFrameStyleonpage 31)andChangingSeat‐to‐FloorHeightonpage 77forrecliner

framestyles.

SEAT-TO-FLOOR

HEIGHT*

SEAT-TO-FLOOR

ANGLE

REFER TO

17½ inches 0° Chart 9

17½ inches 3° Chart 10

17½ inches 6° Chart 11

16½ inches 0° Chart 12

16½ inches 3° Chart 13

15½ inches 0° Chart 14

Chart 9 - Seat-to-Floor Height of 17½ inches and 0° Angle

REAR WHEEL POSITION ANTI-TIP

PART/MODEL

NUMBERS

FRONT CASTER

OFFSET AXLE OPTION STANDARD MOUNTING

POSITION

ADJC CAM

POSITION

FORWARD REARWARD

N/A for this

frame style

N/A On-Chair

1058836

Off-Chair

Hole 4

Hole

2

Hole 4

Hole 2

Front

Notch