Invacare 9000 XT Manual

A SERVICE OF

next previous

SECTION 4—FRONT CASTERS

9000 Series 28 Part No. 1076155

5. Looselytightenthebottomoftheexistingcasterheadtubetothewheelchairframe

usingexistinghardware.

6. Adjusttheseat‐to‐floorangle.RefertoChangingSeat‐to‐FloorHeight/Seat‐to‐Floor

Angleonpage 29.

7. Securethecamtothetopofthecasterheadtubewiththeexistinghardware.

8. Securelytightenthecasterheadtubetothewheelchairframe.Torquelocknutsto

120‐140inch‐lbs.

9. Adjusttheanti‐tippers.RefertoInstalling/AdjustingAnti‐tippersonpage 80.

Repositioning/Replacing Cam

NOTE:Forthisprocedure,refertoFIGURE4.2.

1. Doone(1)ofthefollowing:

•ToReposition‐RefertoChangingSeat‐to‐FloorHeight/Seat‐to‐FloorAngleon

page 29.

•ToReplace‐Beforeremovingthecam,makenoteofthepositionofthecaminthe

casterheadtubeforproperreinstallation.Thenremove.

2. Loosenthebottommountingscrewandlocknutthatsecuresthecasterheadtubetothe

wheelchairframe.

NOTE:Looseningthebottommountingscrewallowsthecamtobepositionedeasilyinthecaster

headtube.

3. Removethetoplocknutandcamfromthecasterheadtube.

4. Installthenew/existingcamatthepositionobservedinSTEP1.

5. Tightenbothlocknutstosecurethecasterheadtubetothewheelchairframe.Torque

to120‐140inch‐lbs.