36
7.8 Using the remote to control the wheelchair
• Switch on the remote (ON/OFF button). The displays on the remote will illuminate. The
wheelchair is ready to start.
• Set the travel speed (buttons for adjusting travel speed - see section on "Assembly of the
remote" on page 30).
Can the electronic system programming be adapted?
The electronic controller is programmed with standard values during manufacture. Your
Invacare® dealer can carry out programming tailored to fit your requirements.
WARNING: Any alteration to the drive programme can influence vehicle handling and the
tipping stability of the wheelchair!
• Alterations to the drive programme may only be carried out by trained Invacare®-dealers!
• Invacare® supplies all wheelchairs from the factory with a standard drive programme.
Invacare® can only assume a warranty for the safe vehicle handling of the wheelchair – in
particular tipping stability - for this standard drive programme!
Will the wheelchair not drive after switching on?
Check the drive-away lock (see chapter "Activate/de-activate the immobiliser " on page 35)
and the status bar indicator (see chapter "Battery charging display" on page 32.).
