555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-7422
5
Rev F
6/08
No.1208-1351
A Division of Thiessen Products, INC
IInnssttrruuccttiioonn SShheeeett FFoorr BBooxx 11 112200”” OOrr 113311””
EEnnggiinnee AAsssseemmbblliieess OOrr EEnnggiinnee RRaaccee KKiittss
Oil Filter Mount for Engine “A” 99-06 FL, 99-05 FXD
• Remove from package and inspect for debris and imperfections.
• Verify the package includes three (3) bolts with washers and one (1) locking flange.
• Check that there are two o-rings present.
Tools necessary for box 1 installation: See Fig.4
3/8” drive torque wrench 5-75 ft/lbs 3/8” drive torque wrench 40-200 In/lbs
3/8” drive ratchet 7/8” deep socket
1/2” 12 point socket 7/16” socket
6” caliper “A” TC Engine Stand, JIMS
®
No.1022
“B” TC Engine Stand, JIMS
®
No.902 Small brass punch, JIMS
®
No.1081
Small brass hammer, JIMS
®
No.1080 20W - 50 clean H-D
®
engine oil
Recommended Tools & Supplies
A small tooth brush
Several lint free cloths
A flashlight
One quart 20W-50 H-D
®
Motor Oil
The following are required to install the cylinder studs:
The furnished six long and two short studs.
The furnished Loctite compound 620.
One (1) furnished cylinder dowel pin tool (1/4” x 1/2”)
One (1) furnished Short Head bolt
A solvent to degrease the threads of each stud. Use Loctite primer, ace
tone, denatured alcohol, rubbing alcohol or other non-residue solvent for
this purpose.
Follow all manufacturer’s instructions and heed all warnings specific to
each chemical used.
A small tooth brush (recommended)
A lint-free cloth.
A flashlight (recommended)
Fig.4 - Tools Required
Alpha Engine
stand shown
use on 99’-06’
JIMS No.1022
Beta Engine Stand
JIMS No.902 Use on all Betas
