4.5. Setting a Broadband Router
When implementing KNS operations via the internet, it is necessary to set the broadband
router connected to the host station.
Perform the settings to transmit control data signals and audio transmissions via the
internet from the broadband router to the host station PC.
This setting depends on the call method of the broadband router manufacturer, and may
be "Port forwarding", "IP masquerade", "Port conversion", "NAT address conversion", etc.
Refer to the user manual for the broadband router used.
The settings are described below.
Control data signals
IP address of the PC used in the host station
Audio transmissions
IP address of the PC used in the host station
Caution:
For the broadband router settings, refer to the broadband router user manual.
Incorrect broadband router settings may stop the network or enable illegal external
access to the network. Take thorough precautions when changing the settings.
JVC KENWOOD Corporation does not offer support for customer PCs and
networks.
