Setting Up Your Printer
32 Kodak ESP 7 Printer User Guide
USB to Ethernet setup
To convert the USB connection from a PC to an Ethernet connection:
1 Disconnect the printer from the computer.
2 Use the Windows Control Panel to delete the printer from you computer.
3 Connect the printer to the network (LAN port on Router) with an Ethernet cable.
4 Run the Kodak Printer Network Setup Utility. This is located on the
Start > All
Programs
> Kodak >Kodak Printer Network Setup Utility. If Macintosh, this
procedure is not necessary.
5 Select
Connect via Network - Ethernet cable, then click Next to proceed. The printer
should be detected and driver installations begin. If you have more than one printer
connected to your network, select the printer then click
Next.
6 After the driver installation completes, click Done to proceed.
7 The printer will be named Kodak ESP 7-XXXX where XXXX is a number unique to your
printer.
Wi-Fi to Ethernet
To convert the Wi-Fi connection from a PC to an Ethernet connection:
1 Connect the printer to the network (LAN port on the Router) with an Ethernet cable.
Ethernet to Wi-Fi
To convert the Ethernet connection from a PC to a Wi-Fi connection.
1 Disconnect the Ethernet cable from the printer.
2 Configure the wireless network from the printer front panel. See “Configuring a wireless
network connection” on page 24.
3 Press
Menu.
4 Press until Network Settings menu is selected, and then press OK.
5 Select
View Network Configuration and confirm you have an IP address.
For Macintosh
USB to Wi-Fi
To convert the USB connection from a Macintosh to a wireless network connection:
1 Disconnect the printer from the computer.
2 Use the Windows Control Panel to delete the printer from you computer.
3 Configure the wireless network from the printer front panel. See “Configuring a wireless
network connection” on page 24.
4 Press
Menu.
