14
Auto flash without red-eye
reduction
Use this mode for taking pictures
without people.
You can change the default setting to
auto flash without red-eye reduction by
following the steps below:
1. Move the ON/OFF SWITCH (20) to the
“ON” position to turn the camera on
and to raise the FLASH (9).
2. Press the FLASH-MODE BUTTON (7)
repeatedly until the AUTO-FLASH
INDICATOR
(36) appears on the
LCD PANEL (5).
3. Frame your subject within the
VIEWFINDER EYEPIECE (19).
4. Partially depress the SHUTTER
BUTTON
(16). When the FLASH/CAMERA-
READY LAMP (18) glows green, fully
depress the shutter button to take
the picture.
• The camera will now default to the
auto-flash mode without red-eye
reduction.
Fill flash
When bright light indoors or outdoors
comes from behind the subject (backlight-
ing), dark shadows (especially on faces)
may occur. Use fill flash to lighten
these shadows.
1. Move the ON/OFF SWITCH (20) to the
“ON” position to turn the camera on
and to raise the FLASH (9).
2. Press the FLASH-MODE BUTTON (7)
repeatedly until the FILL-FLASH
INDICATOR
(32) appears on the LCD
PANEL
(5).
3. Frame your subject within the
VIEWFINDER EYEPIECE (19).
4. Partially depress the SHUTTER
BUTTON
(16). When the FLASH/CAMERA-
READY LAMP (18) glows green, fully
depress the shutter button to take
the picture.
