Output Modes 6-7
Output Modes
Staple-Sort Mode Using Primary (Main) Tray
Use this mode when you want to offset and staple each printed set. Stapling position and
number of staples (1 or 2) can be designated.
Each finished set will be offset from the next printed set.
With the Primary (main) tray initially selected, FS-110/210 outputs the printed sheets
FACE DOWN in the proper order.
❒ Stapled paper at 1 position: 11"x17", 8.5"x14", 8.5"x11"R, 8.5"x11" (5.5"x8.5" is available in
portrait orientation only.)
❒ Stapled paper at 2 positions: only 8.5"x11" paper loaded with larger vertical dimension
11"x17", 8.5"x14", 8.5"x11"R, 8.5"x11" paper loaded with larger
horizontal dimension
❒ Paper capacity for 20 lb: 1,000 sheets (Variable according to the number of pages to be stapled.
See p. 4-5 for details.)
❒ Staple capacity: 50 sheets 20 lb (5.0 mm thick or less)
(Staple capacity is changeable, and may be set to 45, 40, or 35 by your service
representative.)
❒ Staple position: 1 oblique staple*; 2 parallel staples
*: Oblique staple may change to parallel staple when using some print sizes.
NOTE: Using excessively curled paper or some types of thin paper in Staple-sort mode may cause poor results
in arrangement of the stapled sets.
3
2
3
2
1
3
2
1
3
2
3
1
3
2
1
1 oblique staple
2 parallel staples
