Page 11/24
EXTENSION LOUDSPEAKER: This single jack socket can be used to connect an 8-16 ohm extension
cabinet. When an extension cabinet is used the switch (36) should be moved to the on position. Failing to do so will result in
masmatched impedance and will reduce the amplifiers performance and in some cases may cause damage to the amplifier.
Remember to switch back to the off position when not using an extension cabinet.
SERIAL NUMBER: Displays the model number and serial number of the unit.
RECORD OUT: Use to connect to your chosen recording device. This socket will emulate the sound of the output tube
stage so you don’t lose that fantastic sound. Used in combination with the mute switch will enable silent recording.
EFFECTS RETURN:
Note: TT100C rear shown on page 10. TT50C rear features identical other than print details.
¼” (6.3mm)
Connect the output from your external effects to this socket. Use only good quality shielded cables.
EFFECTS SEND: Connect the input of your external effects unit to this socket. Some Effects are better suited to being
between the guitar and amplifer input - these are foot pedal types / distortion / wah wah pedals etc. Rack mount effects will
work better in the FX loop on the amplifer rear. Stomp boxes are normally designed for small signals such as a guitar output
whereas rack mount FX are designed for the higher signal level obtained from an FX send. Use only good quality shielded
cables.
FOOTSWITCH: This is a 15 pin dtype socket for connection of the dedicated Laney FS6 footswitch enclosed with the
amplifier. The FS6 allows remote switching of Channel 1, Channel 2, Channel 3, Volume 1&2 and Reverb. Do not connect any
other device to this socket.
MIDI: See midi section on page 12.
REAR PANEL CONTROLS - CONTINUED
Laney
OPERATING INSTRUCTIONS
