Laney
OPERATING INSTRUCTIONS
SERIAL NO: Displays the model and serial number of the unit.
EFFECTS LOOP RETURN: Connect the output from your external effects to this socket. The effects loop allows you to
connect external effects such as tremolos, chorus and delays to your amplifier. A portion of the signal leaves the amplifier via
the `Send’ socket and comes back from the effects via the `Return` socket. Use the output level control on your FX to control
how loud the FX return signal sounds.
EFFECTS LOOP SEND: Connect the input of your external effect to this socket A ‘side chain’effects loop allows you to
connect external effects such as tremolos, chorus and delays to your amplifier. Signal leaves the amplifier via the `Send’ socket
and comes back from the effects via the `Return` socket. Some Effects are better suited to being between the guitar and
amplifer input - these are foot pedal types / distortion / wah wah pedals etc. Rack mount effects will work better in the FX
loop on the amplifer rear. Stomp boxes are normally designed for small signals such as a guitar output whereas rack mount FX
are designed for the higher signal level obtained from an FX send.
FOOTSWITCH SOCKET: Provided for the connection of a Laney FS2 footswitch (optional) .This allows you to remotely
switch between the clean/drive channel and & switch the built in reverb On/Off.
Page 9 /16
C
1 1
V
5- 10
