8. Setup Mode: Advanced Settings
Expert Settings (Option 5)
Note: You can change the Enable alternate MAC setting using telnet or serial
connections only. It is not available through the Web-Manager.
CAUTION: Only an expert should change these parameters. You must
definitely know the consequences the changes might have.
Figure 8-1. Expert Settings
TCP Keepalive time in s (1s - 65s; 0s=disable): (45) ?
ARP Cache timeout in s (1s - 600s) : (600) ?
CPU performance (0=Regular, 1=Low, 2=High): (0) ?
Disable Monitor Mode @ bootup (N) ?
HTTP Port Number : (80) ?
MTU Size (512 - 1400): (1400) ?
TCP Re-transmission Timeout (500 - 4000) (ms): (500) ?
Enable alternate MAC (N) ?
Ethernet connection type: (0) ?
The default settings are listed below:
TCP Keepalive time in s
(1s – 65s; 0s=disable)
ARP Cache timeout in s
(1s – 600s)
Disable Monitor Mode @ bootup
(1-65535)
0 (resulting in an operational value of 1400)
TCP Re-transmission Timeout
0 (resulting in an operational value of 500)
0 (resulting in auto-negotiation)
TCP Keepalive time in seconds
This option allows you to change how many seconds the unit waits during a silent
connection before attempting to see if the currently connected network device is still
on the network. If the unit gets no response, it drops that connection.
TCP Keepalive time in s (1s – 65s; 0s=disable): (45)? _
xPico User Guide 54
