A SERVICE OF

logo

10
SLEEP To Music Timer
You can program the sleep timer to play the radio for up to “99” minutes and then shut off
automatically.
1.) Press the SLEEP button. The display will briefly show “L:30” and the radio will begin to play.
After 30 minutes the radio will shut ‘Off’ automatically.
2.) To increase or decrease the amount of time that the radio will play before shutting off, hold the
SLEEP button and press either the SET < or > button to change the display to the desired
sleep time, up to a maximum of “99” minutes or a minimum of “01” minute.
NOTE: When you change the sleep timer from the 30 minute default setting to a different
setting, the new setting becomes the default setting. Whenever you activate the sleep timer it
will begin with your new default setting and count down to zero from that point.
3.) To cancel the sleep timer before it counts down to “00” and shut the radio ‘Off’ immediately by
pressing RADIO ON/OFF button or pressing the SNOOZE/SLEEP OFF Bar.
IMPORTANT: Remember that the station and volume settings you choose for the SLEEP To
Music operation are the same settings you will hear if you set the alarm for wake to radio the
following morning.
Display Brightness Control
This automatic time setting
Clock Radio features a unique display brightness control system that
gives you three convenient options:
HIGH When the dimmer switch is set to the “HIGH” position the clock display is always at
full brightness. The dimmer switch was set to the ‘High’ position at our factory.
LOW When the dimmer switch is set to the “LOW” position the display brightness is
reduced by approximately 50%.
OFF/WAVE – When the dimmer switch is set to the “OFF/WAVE” position the display goes ‘Off’
completely. This is designed for people who prefer to sleep in total darkness.
However if you want to see the clock display at any time, slowly wave your hand in
front of the WAVE SENSOR on the front panel. The clock display will immediately
return to full brightness for 10 seconds and then shut off again automatically. The
effective operating range of the Wave Sensor is approximately 12” to 36” from the
front panel.