General information 1-7
7100-XXX
Print engine paper and media specifications
Print area
The printable area is up to 4.0 mm (0.158 in) from the top and bottom of the media, and up to 3.0 mm (0.118
in) from the left and right edges. Any information placed outside this specified printable area will not print.
For envelopes, the printable area is up to 4.0 mm (0.158 in) of the left and right edges, and 3.0 mm (0.118
in) of the top and bottom edges.
Print engine input and output configurations
The following table shows the standard number of input sources and output destinations, as well as the
estimated capacity of each. Capacity may vary and is subject to media specifications and MFP operating
environment. The capacities listed are based on plain paper at 75 g/m
2
.
Sources and capacities X500n / X502n
Input sources
Number of standard sources 1
Number of optional input drawers 1
Maximum number of input sources
1
2
Maximum input capacity 780
Input capacities
2
Standard input
Primary tray capacity 250
Total standard capacity 250
Optional input
Optional tray 1 capacity 250
Optional tray 2 capacity 530
Output destinations
Number of standard destinations 1
Output capacities
Standard output bin capacity (top)
Media up to 20 lb paper 250
1
Optional input drawer is a 530-sheet capacity drawer. Only one optional drawer may be installed at any time.
2
The MFP supports top output (facedown) as standard. No additional output options are available.
Note: All capacities are based on use of 20 lb paper.
