60
WATCHING TV / PROGRAMME CONTROL
WATCHING TV / PROGRAMME CONTROL
INPUT LIST
HDMI, AV, COMPONENT and RGB can be recognized by a detect pin and thus enabled only when an
external device approves voltage.
By using TV/RAD button, you can move from External Input to RF Input and to the last watched pro-
gramme in DTV/RADIO/TV mode.
Antenna
RGB
AV
HDMI
Component
1
Select the input source.
INPUT
• Antenna or Cable : Select it when watching the DTV/TV. (Digital cable input is available only at Finland,
Sweden and “--” country)
• AV : Select it when watching the VCR or external equipment.
• Component : Select it when using the DVD or the Digital set-top box depends on connector.
• RGB : Select it when using PC depends on connector.
• HDMI : Select it when using DVD, PC or Digital set-top box depend on connector.
NOTE
► The OSD (On Screen Display) is displayed on the screen as shown below.
• If you select "Yes," the size and image quality are optimised for your PC.
• If you select "No," the size and image quality are optimised for the AV device (DVD player, set-top
box, gaming device).
• If you select "Do not show message again," this message does not appear until the monitor is
reset. You can change the set value in Menu s Option sInput label.
!
• When turning the product on in HDMI input.
• When switching to HDMI input.
• When connecting an HDMI cable with no signal.
Is the input connected to your PC?
Do not show message again.
Yes No
