Sponsor: Marketing Executive Intamac Quick Install Guide – Linksys Wireless G Camera
Page 2
Version 1
23/03/06
M:\Sales & Marketing\Marketing\Literature\User and Quick Setup Guides\in progress documents\Intamac Quick Install Guide -
Linksys Wireless G Camera.doc
i. Firstly you should establish the port your camera is operating on. To
do this:
1. Access your camera’s web-based utility.
2. Click the ‘Setup’ tab.
3. Click the ‘Options’ tab.
4. Check the ‘Alternate Port’ field at the bottom of the page.
a. If the drop down option reads ‘Disable’, your camera is
currently operating only on the default port (which is
port 80).
b. If the drop down option reads ‘Enable’, your camera is
currently operating on the default port (which is port 80),
and the alternate port number shown.
c. If you need to assign a specific port number to your
camera, select ‘Enable’ from the drop down list, type in
an alternate port number, and click ‘Apply’.
ii. Now you must configure your broadband router to ‘port forward’ to
either port 80, or the alternate port number specified above. To do this
for a Linksys router follow the instructions at www.linksys.com/portfwd.
NOTE: Intamac cannot help you with specific information on
programming non-Linksys routers for port forwarding. Try
www.portforward.com – this site contains a lot of information on
configuring individual routers for port forwarding.
c. Activate Live View in your Intamac account
You must now input IP details into your Intamac online account to enable you to
see live pictures from your camera through your Intamac account.
To do this:
i. Log in to your Intamac account at www.intamac.com
ii. Click Your Devices in the left hand navigation menu.
iii. Click Details next to the camera you wish to activate.
iv. Input a description you understand in the Device Location field (e.g.
Living Room).
v. In the IP address/URL field input either your camera’s external static
IP address (from Step 2ai above) or its DDNS address (from Step 2aii
above). Note:
1. Do not use the ‘http://’ part of the address.
2. Do not use the part before the first ‘.’ of a DDNS address.
3. Add the port number to the end after a colon (:)
4. Add /img/main_fs.htm to the end.
Eg 1: 81.130.205.149:1024/img/main_fs.htm
Eg 2: mydomain.ourlinksys.com:1024/img/main_fs.htm
vi. Click Update to save changes.
NOTE: Refer to the ‘account settings’ section at
www.intamac.com/linksys for more information on IP addresses and
DDNS.
NOTE: Some routers may not allow you to see pictures from your
camera when you are inside your property when you click the ‘live
view’ button on your Intamac account. If you cannot see the live view
and are inside your property, please try using another computer
