A SERVICE OF

logo

42 Optional Equipment (for qualified installers only)
© Travis Industries 4090717 100-01225_000
4 Follow the directions below to replace the orifices.
Screw each LP orifice in so the
orifice protrudes 15/16" (24mm)
(indicating full insertion).
c
Look here for the orifice identification
Apply thread sealant to the LP
orifices prior to installation. Use
the chart below to identify the
correct orifices.
Front
Rear
NG
#50
#47
LP
#56
#56
b
1/2" Wrench
Use a 1/2" open end wrench
to unscrew the two orifices.
Front Burner Orifice
a
Rear Burner Orifice
15/16"
24mm
5 Remove the rivet from the left side of the burner and place it on the right side (see illustration below).
Remove the rivet from this
hole. This burner hole is
plugged when using NG.
Place the rivet in this
hole when using LP.