5. PROBLEM SOLVING
• If the "LOW BAT" icon is displayed on the LCD readout at any time,
the batteries should be replaced as quickly as possible.
• When the unit is in the power on mode and the LCD displays "000%,"
the sensor is not connected properly. The "ATTACH SENSOR" icon
will also appear on the display. Check the sensor connection and if
the condition persists, contact Maxtec's Customer Service
Department.
• If, at any time, "ErX" (i.e. Er1, Er4, etc.) appears on the LCD readout,
contact Maxtec's Customer Service Department.
6. CLEANING AND MAINTENANCE
• When cleaning or disinfecting the MAXO2 Monitor, take appropriate
care to prevent any solution from entering the instrument.
• The MAXO
2
Monitors surface may be cleaned using a mild
detergent and a moist cloth.
• The MAXO
2
Monitor may be disinfected using standard topical
disinfectants.
• The MAXO
2 Monitor is not intended for steam, ethylene oxide or
radiation sterilization.
• Store the MAXO
2 Monitor in a temperature similar to its ambient
environment of daily use.
15
R213M05H.qxd 6/26/2006 9:04 AM Page 14
