AT INTERFACE DESCRIPTION
5 – 5
Ultra DMA TimingUltra DMA Timing
Ultra DMA TimingUltra DMA Timing
Ultra DMA Timing
TIMING PARAMETERS
(all times in nanoseconds)
MODE 0 MODE 1 MODE 2 MODE 3 MODE 4 MODE 5
MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX MIN MAX
t
CYC
C
cle Time (from STROBE ed
e to STROBE ed
e) 112 73 54 39 25 16.8
t2
CYC
Two c
cle time (from risin
ed
e to next risin
ed
e or
from fallin
ed
e to next fallin
ed
e of STROBE)
230 153 115 86 57 38
t
DS
Data setup time (at recipient) 15 10 7 7 5 4
t
DH
Data hold time (at recipient) 5 5 5 5 5 4.6
t
DVS
Data valid setup time at sender (time from data bus bein
valid until STROBE ed
e)
70 48 31 20 6.7 4.8
t
DVH
Data valid hold time at sender (time from STROBE ed
e
until data ma
o invalid)
6.2 6.2 6.2 6.2 6.2 4.8
t
FS
First STROBE (time for device to send first STROBE) 0 230 0 200 0 170 0 130 0 120 0 90
t
LI
Limited interlock time (time allowed between an action b
one a
ent, either host or device, and the followin
action
b
the other a
ent)
0 150 0 150 0 150 0 100 0 100 0 75
t
ML I
Interlock time with minimum 20 20 20 20 20 20
t
UI
Unlimited interlock time 000000
t
AZ
Maximum time allowed for outputs to release 10 10 10 10 10 10
t
ZAH
Minimum dela
time required for output drivers turnin
on
(from released state)
20 20 20 20 20 20
t
ZAD
000000
t
ENV
Envelope time (all control si
nal transitions are within the
DMACK envelope b
this much time)
20 70 20 70 20 70 20 55 20 55 20 50
t
SR
STROBE to DMARDY (response time to ensure the
s
nchronous pause case when the recipient is pausin
)
50 30 20 NA NA NA
t
RFS
Read
-to-final-STROBE time (no more STROBE ed
es
ma
be sent this lon
after receivin
DMARDY- ne
ation)
75 70 60 60 60 50
t
RP
Read
-to-pause time (time until a recipient ma
assume
that the sender has paused after ne
ation of DMARDY-)
160 125 100 100 100 85
t
IORDYZ
Pull-up time before allowin
IORDY to be released 20 20 20 20 20 20
t
ZIORDY
Minimum time device shall wait before drivin
IORDY000000
t
ACK
Setup and hold times before assertion and ne
ation of
DMACK-
20 20 20 20 20 20
t
SS
Time from STROBE ed
e to STOP assertion when the
sender is stoppin
50 50 50 50 50 50
DMARQ
(device)
DMACK-
(host)
STOP
(host)
HDMARDY-
(host)
DSTROBE
(device)
DD(15:0)
t
ZAD
DA0, DA1, DA2,
CS0-, CS1-
t
UI
t
ZAD
t
ACK
t
ACK
t
ENV
t
ENV
t
ZIORDY
t
FS
t
FS
t
VDS
t
AZ
t
DVH
t
ACK
Figure 5 - 4
Initiating an Ultra DMA Data In Burst
