212
Controls in detail
Loading
Pulling partition net tight
3 Lift tensioner
4 Tightening belt
5 Belt hook
6 Cargo tie-down ring
Lift tensioner 3 on tightening belt 4
must point in direction of the windshield
(indicated by the arrow).
̈ Use lift tensioner 3 to set the length
of tightening belt 4 to cargo tie-down
ring 6.
̈ Hook belt hook 5 into cargo tie-down
ring 6.
̈ Pull tightening belt 4 by the loose end
until the partition net is slightly pulled
tight.
̈ Fold the rear seat bench rearward until
it locks into place.
The partition net will be tightened by
the rear seat bench.
̈ After driving a short distance, make
sure the partition net is still tight and, if
necessary, pull it tight again.
Installation partition net behind front
seats
Partition net installed behind front seats
̈ Fold the rear seat bench (together with
the rear seat backrest) forward
(
୴ page 207).
