Problem solving guide
Repair work to electrical appliances should only be carried out by a suitably
qualified person in accordance with local and national regulations. Unauth-
orised repairs could be dangerous.
What to do if, . . . Cause . . . Remedy . . .
. . . No lights come on in the
PROGRAMME column when
the machine is switched on
There is no power. Check that:
– the door is properly closed.
– the mains plug is plugged in.
– the fuse or circuit breaker
has not tripped.
. . . There is an ’0’ in the
“Time left” display, and a new
programme cannot be started.
The machine was not switched
off at the end of the previous
programme.
Switch off and then on again
(I-0 ) switch
. . . The “Check lights” are
flashing
The water inlet is blocked. The
“Check water inlet” LED is
flashing.
– The stopcock is not opened
far enough.
– The inlet hose is kinked.
– The water pressure is too
low. Call the Service Dept.
The water inlet system is
blocked. The “Check water
inlet” LED is flashing.
– Switch the machine off.
– Open the stopcock.
– Select a programme and
start again.
The water outlet is blocked.
The “Drain"( check water outlet)
LED is flashing.
– Clean the drain pump and
fluff filter.
– Has the drain pump been
fixed too high? (max drain
head 1 metre).
The Waterproof system has
reacted to a leak.
The “Check water inlet" and
“Drain” LEDs” are flashing.
Call the Service Dept.
Problem solving guide
29
