Learn a key
IIf you miss certain functions from your original remote control of the
RU760, the RU760 can learn these functions from the original remote.
You can store a fuction under any of the available keys of the RU760, except
LEARN, SELECT and SHIFT. Please, note that any function already stored
under a key will be deleted.
Example for VCR:
Make sure you have the original VCR remote control at hand.
1 Select the device mode VCR, with the
SELECT key.
2 Press the LEARN key and the target key on
the RU760 simultaneously for 5 seconds,
until the VCR label blinks twice and remains
lit.
3 Place both remote controls on a flat surface
(like a coffee table) and aim them head-to-
head with about 10cm in between.
4 Press the button you want to copy on the original remote control.
– If the RU760 has learned the code, the VCR label will blink twice to
confirm the signal is stored.
– If the VCR light blinks once for a longer period, the IR signal is not
learned by the RU760. Please, try a few times and make sure the
remotes are aligned as described in step 3.
If the RU760 cannot learn the code after several times trying, it is possible
that:
– The IR signal of your original device is out of range (the RU760 can
only learn IR signals with a carrier signal of 30-60kHz.
– The memory of the RU760 is full.
– The RU760 stopped the learning process after 20 seconds if no
IR signals are found. Check if your original remote control is working
correctly.
10 cm.
