3. Press or to display the number of stop bits you
need, then press . You will see
PORT SETTINGS
< Stopbits >
4. Press to exit to the Setup menu.
5. Press to exit to the Main Menu.
NOTE: After changing settings in the Setup Menu, always
return to the Main Menu before turning your
printer off. The printer will not save changes to
these menus if you turn it off before returning to
the Main Menu.
Parity
The default setting for Parity is None. To change the setting,
follow the steps listed under "Finding Communication Value
Options." Then follow the steps below.
1. Press until you see
PORT SETTINGS
<Parity>
2. Press . You will see the previous setting, for example,
PARITY
None >
The options for parity are
None
Odd
Even
Setting Communication
Values
Setting the Communication Values
4-5
