1.18
Getting started
Acceptable document size
The acceptable dimensions as follows:
Automatic document feeder (
ADF
) (width × length)
S
INGLE
-
SHEET
M
ULTIPLE
-
SHEET
Maximum: 300 × 900 mm (Tx) 297 × 420 mm
300 × 450 mm (Copy)
Minimum: 120 × 100 mm 148 × 105 mm
Weight: 30.2 – 104.7 g/m
2
52.3 – 104.7 g/m
2
You can set up to about 50 sheets of A4, 40 sheets of B4 or 30 sheets of A3 sized
document in the ADF at a time.
Flatbed scanner (
FBS
) glass (width × length)
Maximum: 297 × 420 mm
Things not to put in your machine
To avoid paper jams and damage to your machine, don’t insert:
• Folded, curled, torn, wrinkled or very thin pages
• Documents with staples, glue, tape, paper clips or still-wet correction fluid
• “Sticky notes” (or documents with “sticky notes” attached)
• Cardboard, newspaper or fabric
• Pages with duplicating carbon on either side
• Credit cards or any small, thick items
How to set the document
When set the documents in the Automatic Document Feeder
1
Set your document face up into the docu-
ment feeder. The document should be
aligned to the rear left corner.
2
Adjust the document guide to fit your docu-
ments.
Note: You cannot set the different sized docu-
ment at a time.
When set the documents on the FBS glass
1
Lift the platen cover fully.
2
Set your document face down
on the
FBS
glass. The document
should be aligned to the rear
left corner.
3
Gently close the platen cover.
Note: If you do not lift the platen
cover fully, the document size
will not be detected automatically.
Auto document size detection
The following sized documents are automatically detected.
• A3 (297 × 420 mm)
• B4 (257 × 364 mm)
• A4 (210 × 297 mm)
• B5 (182 × 257 mm)
• A5 (148 × 210 mm)
How to set the document
