English
29
Problem: Image is reversed.
4
Press “Menu”button then select “Display” to adjust the projection.
Problem: Lamp burns out or makes a popping sound
4
When the lamp reaches its end of life, it will burn out and may
make a loud popping sound. If this happens, the projector will not
turn on until the lamp module has been replaced. To replacethe
lamp, follow the procedures in the “Replacing the Lamp”section on
page 30.
Problem: LED lighting message
Message
Power LED Temp LED Lamp LED
(Blue) (Orange) (Red)
Standby State
Off Off Off
(Input power cord)
Power on On Off Off
Power off Flashing Off Off
Error (Lamp fail) Flashing Off On
Error (Thermal switch) Flashing On Off
Error (Thermal Pre-cooling) Off Flashing Off
Error (Fan lock fail) Flashing Flashing Off
Error (Over Temp.) Off On On
Error
Flashing Off On
(Lamp Breakdown)
Problem: Message Reminders
4
“Lamp may fail soon! Replacement suggested!” will be shown
about 10 seconds when lamp life is going to deplete.
4
“Over Temperature” will be shown momentarily before shutdown
if system temperature is too high.
4
“Fan Fail” will be shown mometarily before shutdown is fan is out
of order.
Appendices
