4
2
1
1. Remove protection cap and insert
the plug. (
1
~
2
)
2. Connect the charger. (
3
~
4
)
3. During charging the LED indicator
lights red. (
5
)
Projector will not charge while
operating.
4.
The LED Charge Indicator will go off
when battery is fully charged. This
process may take up to 2.5 hours
4
5
CHARGING THE BATTERY
3
1
2
CONNECT INPUT SOURCE - (VIDEO IN)
1
2
1
2
or
or
1. Connect the AV input source.
(
1
~
2
)
2. After powering on projector, press
"Auto Search Source Button" to
change sources.
3. Connect external speakers to the
audio out connector of the projector.
(
3
)
<Note>
1. All other brand and product names are
trademarks or registered trademarks of their
respective companies.
2. The connecting cable of video output
device is not supplied, please contact their
service center.
3. iPod nano/iPod touch/iPhone/iPod classic
(version 5 and above)
4. Designed for iPod/iPhone/Mobile phone/
PMP with TV out functions. Using with
device with audio signal voltage > 0.3Vrms
is not recommended.
CONNECT INPUT SOURCE -
(VGA/USB/HDMI/COMPONENT IN)
1
2
1
2
MOLEX
1
2
1
2
or
1. Connect the VGA/Component
source device with the Universal
I/O connector. (
1
~
2
)
2. After powering on projector, press
"Auto Search Source Button"
to change sources.
Insert universal connector
with arrow mark facing up.
<Note>
1. For more LED indicator, see page 7.
2. After the projector is turned off, the
battery may not start charging right away
due to over temperature protection.
CONNECT INPUT SOURCE DATA TRANSFER
<Note>
1. USB device: Support USB Flash Drive
up to 5V/150mA, but does not support USB
Hard Disk Drive
2. Female USB cable, Component cable,
and HDMI cable are optional accessories.
<Note> The laptop/PC can only detect
the input source when the Projector is
switched on. The projection will stop when this
connection is made.
1. Connect laptop or PC for data
transfer to the Projector internal
memory or additional MicroSD
memory using the supplied Male
USB Cable. When connected,
switch the Projector on.
<Optional>
The PK201 can also be charged via USB to
DC cable (
6
)
M
O
L
E
X
M
O
L
E
X
1
2
or
I
NSERT MICROSD CARD
1. Insert a MicroSD card into the
slot with the gold contacts facing
down.
3
or
1. Connect the HDMI source device
to the mini HDMI connector.
2. After powering on projector, press
"Auto Search Source Button"
to change sources.
or
1. Connect the USB flash drive to
the micro USB port using the
female USB cable.
2. Select USB Flash Drive from
the Main Menu.
