Manual tuning
[l TUNE]: Higher frequency
[k TUNE]: Lower frequency
Seek tuning
Press and hold ...
[l TUNE]: Higher frequency
[k TUNE]: Lower frequency
Tuning will automatically stop when the signals of the next broadcast station are received.
»
Radio mode
Press [SRC] (source) to change to the radio mode.
ᕡ
Direct Memory (D
·
M)
Your favorite FM/AM radio station can be memorized in the [D
·
M] button and you can call back radio stations
just by pressing the button whatever the current sound source is, even if the power is off.
Default : FM 87.5 MHz
Band
Press [BAND] to change the band.
·
Press [D·M]. (Press again to cancel)
¡The direct memoried station is received.
Recalling the direct memory
FM Stereo indicator
e
Release [D
·
M] button. Then, new station will be over-
written on existing saved station.
ᕢ
Press and hold [D
·
M] until the Frequency display blinks.
ᕡ
Select the station in Radio mode (➡ above)
Memorize
blinks
Band
Press [BAND] to select a desired band. (➡ page 8)
Preset station setting
Up to 6 stations each can be saved in the FM1, FM2,
FM3 and AM preset station memories.
Note: Existing saved stations are overwritten with
new stations after following this procedure.
Display change
Press [DISP] (display) to switch to the clock display.
Caution: To ensure safety, never attempt to preset
stations while you are driving.
Manual preset memory
ᕡUse manual or seek tuning to find a station.
(➡ page 8)
ᕢPress and hold one of the preset buttons
from [1] to [6] until the display blinks once.
Auto Preset Memory (APM)
Press and hold [BAND] (APM: auto preset memory) for more than 2 seconds.
• The 6 stations with good reception will be automatically saved in the memory
under preset buttons from [1] to [6].
• Once set, the preset stations are sequentially scanned for 5 seconds each.
Preset station calling
Press the corresponding preset button from [1] to
[6] to tune in a preset station.
q
blinks once
D
·
M indicator
