11
6. TIMER OPERATION
• When setting the timer, make sure the current time on the remote controller is accurate.
• The timer’s clock can only be set when the display of the remote controller is ON.
• After setting the timer, put the remote controller in a place where its signal will reach the receiver of
the indoor unit. (When the time set for the timer is reached, a signal is sent from the remote
controller to Start/Stop the unit.)
Using the Timer
1. Press either
/
of the
or
, and while the time is
being displayed, if you press
/
again, a scheduled time can
be set.
The time last set on the timer is displayed.
“--:--“ indicates time to change the batteries.
2. Press either
/
of the
or and set the timer to the
desired time.
Every time you press
/
, the time changes in 10 minute increments.
If you press and hold the button, the time changes quickly.
3. After setting the timer, if you press , the time you set
changes to a steady display, indicating settings are complete.
After the timer setting is displayed for three seconds, the display reverts to
the current time.
1, 23
