Operating Instructions | 9
Manual Registration continued.
• Press ‘off hook’ on the handset. The
green LED will go steady ON.
• Enter a unique identifying number on the handset keypad for each repeater
registered. The identifying number can be 2 to 7 for domestic DECT products,
and 000 to 255 for PBX DECT products. The digit will display on the handset
screen.
• The green LED will flash to correspond
with the dialled digit. i.e digit 5 will
cause the green LED to flash 5 times.
For PBX use the digit 0 will cause the
green LED to flash 10 times. i.e digits
025 will cause the green LED to flash
10 times for ‘0’, then a delay of 2
seconds, then flash 2 times for ‘2’, then
a delay of 2 seconds, then flash 5 times
for ‘5’. You do not have to wait for the
confirmation flashes when registering.
• Dial “*” on the handset to store the
identifying number to memory. The
green LED will go off for 1 second.
If the identifying number entered is
already assigned, the red LED will light
for 1 second. A new identifying number
must then be entered followed by “*”.
The green LED will then flash slowly for
a short period of time before going
steady ON. Registration is complete.
• If the registration is not successful, the red
LED will turn steady ON. In this case, repeat
the registration process.
QUQX00130YA_01_A 20/1/04 6:40 pm Page 9
