8. Help
48
Troubleshooting
8.3 When a function does not work, check here
8.3.1 Initial settings
8.3.2 General
Problem Cause & Solution
I cannot hear a dial tone. L The telephone line cord is connected to the [EXT] jack on the unit.
Connect to the [LINE] jack (page 15).
L If you use a splitter to connect the unit, remove the splitter and
connect the unit to the wall jack directly. If the unit operates
properly, check the splitter.
L Disconnect the unit from the telephone line and connect a known
working telephone. If the working telephone operates properly,
contact our service personnel to have the unit repaired. If the
working telephone does not operate properly, contact your
telephone company.
L The power cord or telephone line cord is not connected. Check the
connections.
L If you connected the fax machine through a computer modem,
connect the fax machine directly to a telephone line jack.
I cannot make calls. L The dialling mode setting may be wrong. Change the setting
(feature #13 on page 40).
The unit does not ring. L The ringer volume is turned OFF. Adjust it (page 16).
Problem Cause & Solution
The other party complains
they only hear a fax tone
and cannot talk.
L FAX ONLY mode is set. Tell the other party the number is only used
for faxes.
L Change to TEL mode (page 32) or TEL/FAX mode (page 33).
The {REDIAL/PAUSE}
button does not function
properly.
L If this button is pressed during dialling, a pause will be inserted. If
pressed immediately after a dial tone is obtained, the last number
dialled will be redialled.
The receiving mode does
not function properly.
L The Distinctive Ring is set (feature #31 on page 36).
During programming, I
cannot enter the code or
ID number.
L All or part of the number is the same. Change the number: feature
#12 (page 40), #41 (page 42) and #49 (page 42).
The unit beeps. L Recording paper has run out. Press {STOP} to stop the beeps and
install paper.
FL613HK-PFQX2156ZA-en.book Page 48 Friday, January 7, 2005 5:54 PM
